Cove, powered by NeuroNova Co
Join our email list
Get exclusive deals and early access to new products.
Chair instructions
How to assemble your chair
Your chair includes four components:
1. Flip seat upside down. Insert rod into hole in seat; press firmly.
Align hole in base with rod. Insert and press firmly.
While chair is upside down, screw cord head carefully into threaded socket. The head and socket must nest exactly to turn smoothly. Tighten until the head will not turn further.
Roll the chair onto its side, then to an upright position.
Sit firmly on the chair to seat all fittings in place.
This will permanently assemble your chair.
Connecting to wifi
Connecting your chair to WiFi ensures your chair receives firmware updates to operate optimally. Without connecting to WiFi (or if WiFi becomes disconnected), the chair will operate only 100 sessions and stop. If your chair unexpectedly stops working, check that it is connected to WiFi.
Using your chair
Power: Turn chair on and off using the power button. When not in use, we recommend keeping power off (unit may remain plugged in). When powered on, the start button will glowsteady blue.
Start/Stop/Pause: Begin a session by pressing the “start” button. A session lasts 10 minutes. To pause a session, press the “start” button again. The start button will blink. You may pause a session for up to 10 minutes, pressing “start” again to resume and complete your session. If you pause for longer than 10 minutes, the chair will reset.
Note: When the blue light is blinking, the chair is connecting to wi-fi or downloading firmware updates. Once the blue light has stopped blinking, the chair is ready for use.
Intensity: Dial the vibration intensity up or down to your comfort level. We recommend higher intensity for large/tall adults, and lower intensity for those with smaller frames and lower body mass.
Changing intensity does NOT change the vibration frequency, which is calibrated to 80Hz for all sessions and intensity levels.
