Join our email list
Receive our latest news, articles, and updates.
Assembly instructions
How to assemble your device
Your device includes four components:
1. Flip seat upside down. Insert rod into hole in seat; press firmly.
Align hole in base with rod. Insert and press firmly.
While device is upside down, screw cord head carefully into threaded socket. The head and socket must nest exactly to turn smoothly. Tighten until the head will not turn further.
Roll the device onto its side, then to an upright position.
Sit firmly on the seat to set all fittings in place.
This will permanently assemble your device.
Connecting to wifi
Connecting your device to WiFi ensures your device receives firmware updates to operate optimally. Without connecting to WiFi (or if WiFi becomes disconnected), the device will operate only 100 sessions and stop. If your device unexpectedly stops working, check that it is connected to WiFi.
Device controls
Power: Turn device on and off using the power button. When not in use, we recommend keeping power off (unit may remain plugged in). When powered on, the start button will glowsteady blue.
Start/Stop/Pause: Begin a session by pressing the “start” button. A session lasts 10 minutes. To pause a session, press the “start” button again. The start button will blink. You may pause a session for up to 10 minutes, pressing “start” again to resume and complete your session. If you pause for longer than 10 minutes, the device will reset.
Note: When the blue light is blinking, the device is connecting to wi-fi or downloading firmware updates. Once the blue light has stopped blinking, the device is ready for use.
Intensity: Dial the vibration intensity up or down to your comfort level. We recommend higher intensity for large/tall adults, and lower intensity for those with smaller frames and lower body mass.
Changing intensity does NOT change the vibration frequency, which is calibrated to 80Hz for all sessions and intensity levels.
